After the water had come to a boil, Dylan went ahead and slipped his gloves on...and then pulled his goggles into place. He wasn't working with the most dangerous ingredient yet...but it seemed logical considering there were others in the lab that could've made mistakes...and caused explosions. After all...not everyone had his talent, of course.
Ahem.
Knowing the steps by heart...since he'd wrote them...the Slytherin went ahead and began preparing the dittany plant. He'd already scourgified all his things, knives, stirring rods, dropper...So, all was good to go.
Naturally, Dylan started blossom first, working the knife against the delicate pieces. It was monotonous and careful business...but after several minutes, that was done...and he was able to knock out the leaves and stem, as well...Which were less time-consuming in comparison. Inspecting stuff after having finished, he felt satisfied that they were in the best condition they could be...and glanced at the cauldron. The water was boiling.
Within the next second, the dittany was being added in...
He quickly crossed out those steps in his notes, prepared to spell the offending marks away later.
SPOILER!!: Dylan's Potions notebook!
Dylan Montmorency
Slytherin Seventh Year Potions Homework #1: Respectfully Untitled IngredientsWater 1/2 cup of dittany (finely chopped) - 1/2 cup of graphorn horn (crushed into a fine powder)
- 6 ounces of blood
- 2 ounces of mercury
Steps and ProcedureClean cauldron and all utensils (Scourgify!) - Fill cauldron with water (Aguamenti!) Allow water to come to a boil.
- Make sure gloves and goggles are in place!
- Use tempered steel knife to chop the dittany plant. Use all parts (blossom, leaves, and stem).
Add the dittany in with the boiling water. Let stew for ten minutes, stirring occasionally. - Using mortal and pestle, crush up parts of the graphorn horn into a fine powder (broken down into smaller (crush-able) pieces outside of the lab).
- Add slowly to cauldron in teaspoon measurements, stirring twice (clockwise) after each.
- Let stew for ten more minutes, stirring occasionally (any direction).
- Add whole vial of blood...(potion should turn dark blue).
- Stir twenty (20) times (counterclockwise).
- Turn burner off and let mixture cool completely. (Must cool naturally and not by magical means!)
______Next steps to be performed with caution! - Once potion is completely cooled, removed the stopper to the mercury and use the crystal dropper to measure out two (2) ounces. Immediately replace the top once finished.
- When adding this ingredient, touch the dropper tip to the potion surface, expelling it into the liquid. (clean the dropper immediately)
- Stir five times (clockwise) with a CRYSTAL stirring rod.
- Let stand for two (2) minutes. Potion should slowly turn dark red.
- After the two minutes, immediately place samples into vials and clear the mess away.